Metal Building Prices in Nueces County, Texas
Installed price ranges below are engineered to Nueces County's design loads — 150 mph design wind speed, TDI windstorm (WPI-8) certification, and no governing snow load. Pick a size for the full breakdown.
Serving Corpus Christi, Robstown, Port Aransas, Bishop, Agua Dulce and the rest of Nueces County.
| Design wind speed | 150 mph — Coastal high wind |
|---|---|
| Ground snow load | 0 psf — non-governing |
| Seismic design category | A — non-governing in TX |
| TDI windstorm (WPI-8) | Required — catastrophe area |
| Region / county seat | Coastal · Corpus Christi |
| Permitting office | Nueces County Dept of Public Works |
Prices by size in Nueces County
| Size | Sq ft | Installed range |
|---|---|---|
| 12×20 | 240 | $4,400 – $8,000 |
| 20×20 | 400 | $7,400 – $13,500 |
| 20×30 | 600 | $11,100 – $19,700 |
| 24×30 | 720 | $13,500 – $24,000 |
| 30×30 | 900 | $16,600 – $30,100 |
| 24×40 | 960 | $17,800 – $32,000 |
| 30×40 | 1,200 | $20,900 – $36,900 |
| 30×50 | 1,500 | $25,800 – $46,100 |
| 40×40 | 1,600 | $27,700 – $49,200 |
| 30×60 | 1,800 | $30,800 – $55,400 |
| 40×60 | 2,400 | $41,200 – $73,800 |
| 50×50 | 2,500 | $43,100 – $76,900 |
| 50×60 | 3,000 | $51,700 – $81,200 |
| 40×80 | 3,200 | $55,400 – $86,700 |
| 40×100 | 4,000 | $68,900 – $108,200 |
| 50×80 | 4,000 | $68,900 – $108,200 |
| 60×80 | 4,800 | $82,400 – $129,800 |
| 50×100 | 5,000 | $86,100 – $135,300 |
| 60×100 | 6,000 | $103,300 – $162,400 |
| 60×120 | 7,200 | $124,200 – $195,000 |
| 80×100 | 8,000 | $137,800 – $216,500 |
Estimated range based on 2026 market data and Nueces County design requirements. Final pricing requires a dealer quote.
Building in Nueces County
Nueces County is open-coast wind country at 150 mph design wind speed — among the highest in Texas. Buildings here are engineered for direct hurricane exposure: heavy-gauge frames, dense fastening, upgraded anchorage, and stamped drawings are not optional. This is the single biggest driver of the price band above, and it's why a building in Corpus Christi costs more than the same size inland.
TDI windstorm certification (WPI-8) applies here
Nueces County is inside a Texas Department of Insurance (TDI) designated catastrophe area. To insure a structure through the Texas Windstorm Insurance Association (TWIA) — and often to satisfy the local building department — the building must be engineered to TDI standards and pass a WPI-8 windstorm inspection. In practice that means TDI-approved product evaluations, an engineer's design that meets the county wind load, and inspection at framing and completion so the installer can file for the WPI-8 certificate of compliance.
Budget for engineered, stamped plans and the inspection itself. Skipping certification can leave the building uninsurable against wind and hail in this county, so we've built the WPI-8 premium into the coastal price band rather than hiding it.
Foundation & slab in Nueces County
Steel is only half the job — the concrete under it is the other half. Gulf Coast soils are typically soft coastal clay and sand with a high water table. Slabs here usually need a thicker turned-down edge, more reinforcement, and sometimes select fill — the concrete line item runs higher than the Texas average, and a soils report is money well spent. The slab range shown in the estimator is a Texas-typical figure; your final number depends on a soils report and the local ready-mix price.